Widebody FB with FD Running Gear

Antnicuk · Post by **Antnicuk** » Sun Apr 01, 2012 8:18 pm

well i brought the car home today, it is now fully rolling on FD running gear but still a long way from being anywhere near done. Things will slow down a bit now as i have a load of work to do to my M3 before we go to the ring next month.

MelloYello · Post by **MelloYello** » Wed Apr 04, 2012 7:21 am

Wow bit of an important milestone to get it rolling. Looks great.
Suprised that the wheel base fits under arches! This is gonna be a weapon

Antnicuk · Post by **Antnicuk** » Wed Apr 04, 2012 9:49 pm

i was up against it as my cousin is moving workshop to a smaller one and that was where i was storing the shell. I could have eventually got the shell home not rolling but it was easier to put my mind to it and get it rolling at the workshop as my cousin has a ramp there.

From what i can find out the wheel base is only 10mm shorter but 3 inches wider. Those measurements seem to ring true now i have got it rolling. There wont be any updates for a while now

Johnnyboy · Post by **Johnnyboy** » Thu Apr 05, 2012 11:17 am

I say again, impressive work.

ian65 · Post by **ian65** » Thu Apr 05, 2012 6:05 pm

great to see my old shell on its wheels at last! Looking good.

ian65 · Post by **ian65** » Sun Jun 10, 2012 8:44 am

Any updates on this project Tony?

BO0557 · Post by **BO0557** » Tue Jun 12, 2012 9:41 pm

Far out!!! That's a nice bit of fab work to get the fd wheels and setup,in..

Antnicuk · Post by **Antnicuk** » Thu Jun 21, 2012 3:08 pm

no updates im afraid, had a few holidays over the last few months and had to get the M3 ready for the Nurburgring. I need to spend the summer

getting the workshop and back garden finished so i wont really be doing much before the winter.

Antnicuk · Post by **Antnicuk** » Tue Sep 11, 2012 8:48 pm

due to some changes in my circumstances i maybe selling this project. Before i go through the saga of ebay, would anyone be interested in it?, it hasnt changed from above, its just sitting in my workshop. I also have LOTS of parts to finish the car, in fact just about all parts needed. It still needs some welding but nothing too complicated.

Antnicuk · Post by **Antnicuk** » Sat Sep 15, 2012 9:33 pm

I have decided this is definitely going now, i dont want a lot for it and may get more scrapping it once any useful bits are sold, it has a full interior also, does anyone want any bits for it?
I am also selling the wide arch body kit if you know anyone that wants one.

www.RX7fb.com

Widebody FB with FD Running Gear

Re: Widebody FB with FD Running Gear

Re: Widebody FB with FD Running Gear

Re: Widebody FB with FD Running Gear

Re: Widebody FB with FD Running Gear

Re: Widebody FB with FD Running Gear

Re: Widebody FB with FD Running Gear

Re: Widebody FB with FD Running Gear

Re: Widebody FB with FD Running Gear

Re: Widebody FB with FD Running Gear

Re: Widebody FB with FD Running Gear