Wiring Loom Connector - For S3 Wanted

[DKWW2000]

I am after a wiring loom, or just the connector with 2" of cables left, it is located on the nearside inner wing bulkhead in a rubber cover & feeds the Carb, oil pressure switch, Temp sender etc, it is the male half with pins to make up a loom hat is needed:-

[danny]

what is the problem with the connector? you can re-tract a pin out of it, use a very small flat screwdriver at the wire-side and lift a clip inside the connector. repare the connection, wire/pin when it's out. mostly corrosion on the wire.

[DKWW2000]

what is the problem with the connector? you can re-tract a pin out of it, use a very small flat screwdriver at the wire-side and lift a clip inside the connector. repare the connection, wire/pin when it's out. mostly corrosion on the wire.

Thanks for the advice, I have just changed my Carb for Twin SUs & need to replace the wiring loom with one of my own design but just need the connector as I do not want to destroy my original should I choose to restore the Nikki setup,see Topic:- http://www.rx7fb.com/viewtopic.php?f=33&t=3974