Page 1 of 1
GSL SE Exhaust
Posted: Tue Jan 05, 2016 12:20 am
by 84gslse
I have an 84 gslse and I'm in the middle of installing a new racing beat exhaust for it, however I purchased the presilencer with the extra tube coming out for the 6 port actuator valves however on the old exhaust I just removed the tube is gone and there is a plug in place of the whole and no piping coming down anywhere to connect to. Does anyone have pics of the tube/pipe that should be coming down to connect to and/or where it should connect under the hood? This would be greatly appreciated. Thank you
Re: GSL SE Exhaust
Posted: Tue Jan 05, 2016 11:49 am
by spirit r
Rx7 GSL SE 6 Port never sold in Europe so Picture are very rare especially Racing beat exhaust picture.
Found these instructions on RB Hompage for you:
http://www.racingbeat.com/manuals/95176-Header.pdf
- 16402.1.jpg (35.15 KiB) Viewed 4148 times
Re: GSL SE Exhaust
Posted: Thu Jan 07, 2016 12:42 am
by 84gslse
That is the presilencer I have and I have the documents from racing beat its more the parts that should be on my 7 that I need to connect to that I am inquiring about. More so where does that tube that comes off the presilencer eventually connect to the engine?
Re: GSL SE Exhaust
Posted: Thu Jan 07, 2016 1:39 am
by KiwiDave
Have you asked for advice on rx7.com? It's likely there will be a few stateside GSL-SE owners on there that could supply photos and such.