Page 13 of 18
Re: Project 'Dont fear the rotor'
Posted: Tue May 14, 2013 10:35 am
by Rexi84
Re: Project 'Dont fear the rotor'
Posted: Sat May 25, 2013 6:35 pm
by Rexi84
Re: Project 'Dont fear the rotor'
Posted: Tue Jun 04, 2013 10:13 pm
by Rexi84
Re: Project 'Dont fear the rotor'
Posted: Wed Jun 05, 2013 7:09 am
by ian65
those seats look the biz Adam, I want some!
Tell us the SP on those aero mirrors then. I seem to remember you bought lhd mirrors from the US and we have always been under the impression that due to the stalks, they wouldn't give the correct field of vision on a rhd car. Did you have to do any mods to them to get them to work and basically, can you see out of them!?
If they are just plug and play and work perfectly I can see a rush of orders for them from the US as they are plentiful and cheap over there.
What's the driving experience like now on your ported engine, much difference over the stock lump?
Re: Project 'Dont fear the rotor'
Posted: Wed Jun 05, 2013 7:53 am
by Rexi84
Thanks ian, i originally purchased 2 sets of mirrors off ebay and on closer inspection or rather me actually emptying the whole package out i realized 1 set had not come with mounting brackets. The other set had so i just bolted everything up, the mounting brackets were wedge shaped so i put the wider end to the top of the door. There was a stamp mark on the brackets and this put the mark upside down so im not sure if i have reversed them or that's how they originally fitted. I havent fitted up the electrics as they need wired up and just wanted to see how they looked. The drivers side is fine, i can see what i need to see, the passengers side is ok as long as i sit forward to see or sit right back in my seat. Im not to fussed about the passenger side too much can live with it. So i havent modded anything but the passenger side could be modded to get a better field of view. As for driving the car loving it, its loud and definatly drives with more urgency.

. The carb could do with looking at and getting set up better but happy so far.
Re: Project 'Dont fear the rotor'
Posted: Sun Jun 09, 2013 2:37 pm
by rivalrx
Great progress. Those mirrors look better on the ol fb that uk stock.
The FC seats are comfy as too
Re: Project 'Dont fear the rotor'
Posted: Mon Jun 17, 2013 9:21 pm
by Rexi84
Re: Project 'Dont fear the rotor'
Posted: Mon Jun 17, 2013 11:09 pm
by Chud
What specs have you gone from and too - and where did you buy the goodies from?
Re: Project 'Dont fear the rotor'
Posted: Tue Jun 18, 2013 11:11 am
by Rexi84
The carb originally had 37 choke tubes, f11 emulsion tubes, 120 air correcter jet, 170 fuel jets and the float needle was a 200. Ive upgraded to 42 choke tubes, 170 air correcter jets, 240 fuel jets and a 300 float needle, emulsion tubes stayed the same. Got all the goodies from aldon automotive in brierley hill. Some stuff was in stock the rest was ordered and was ready for pick up in couple of days.
Re: Project 'Dont fear the rotor'
Posted: Thu Mar 20, 2014 8:34 pm
by Rexi84