Page 2 of 4
Re: Brake/clutch flexi pipes
Posted: Sun Aug 12, 2012 12:15 pm
by Lucky
I haven't had a chance to get them done yet... run out of time and money a bit just now
Re: Brake/clutch flexi pipes
Posted: Wed Oct 17, 2012 9:46 pm
by DB RX63
DB RX63 wrote:Have you had them delivered yet ?
Where did you get them done ?
Re: Brake/clutch flexi pipes
Posted: Wed Oct 17, 2012 9:47 pm
by DB RX63
Are S2 and S3 hoses the same ?
Re: Brake/clutch flexi pipes
Posted: Thu Oct 18, 2012 8:51 am
by TOOL
DB RX63 wrote:Are S2 and S3 hoses the same ?
Different thread pitches. S2 is coarse and S3 is fine. 1.25 vs 1.0 from memory.
Re: Brake/clutch flexi pipes
Posted: Thu Oct 18, 2012 8:59 pm
by DB RX63
Reliable with the info as ever Andrew, thanks.
The length should be the same though?
Re: Brake/clutch flexi pipes
Posted: Thu Oct 18, 2012 10:34 pm
by ian65
I think the front flexibles are different lengths too
Re: Brake/clutch flexi pipes
Posted: Fri Oct 19, 2012 9:01 am
by TOOL
Which ones are you after? S2 or S3?
Re: Brake/clutch flexi pipes
Posted: Fri Oct 19, 2012 11:11 am
by DB RX63
I have a new set of S2 flexi's but need a S/S set for an S3 (poss with FC hub, discs etc) and just thought i might be able to use the S2 set as a pattern.
Perhaps I should have explained that !
Re: Brake/clutch flexi pipes
Posted: Fri Oct 19, 2012 11:33 am
by BO0557
check online like car builder solutions or one of the rally shops like jjc race cars and see if they have a M10x1.25 to M10x1.0 adapter..
you may be able to get them and use them Derek...
As for the FC they are 1.0 pitch
Re: Brake/clutch flexi pipes
Posted: Fri Oct 19, 2012 4:23 pm
by Casey
TOOL wrote:DB RX63 wrote:Are S2 and S3 hoses the same ?
Different thread pitches. S2 is coarse and S3 is fine. 1.25 vs 1.0 from memory.
Can someone confirm that? I thought the S1 used 1.25mm pitch but the S2 and S3 both used 1.0mm? Important as one of the jobs on my list is to remake the hard brake lines on the rear (S2) axle of Kimi!